Bifold Door Opening Measurements: Frame vs Brickwork
The size of the hole in your wall is not the size of the bifold doors you should order. Installation allowances, squareness, support and threshold details all change the finished frame dimensions.

Understand three different measurements
The structural opening is the space between the supporting wall edges. The outer frame has a separate width and height. The clear walk-through opening is smaller again, because the frame, meeting stiles and the folded panels occupy room. Mixing these figures can produce expensive ordering mistakes.
Before requesting prices, note the approximate wall opening and whether you are replacing an existing doorset or creating a new opening. Photograph the head, reveals, sill and adjoining floor. Your installer will use the final surveyed measurements and the selected bifold system to decide the exact manufacturing dimensions.
Why you cannot just order the brickwork size
Walls are rarely perfectly square. A professional survey checks width at different heights, height at different positions, level at the sill and whether the masonry is plumb. The frame needs appropriate fixing and sealing details, with allowance determined by the manufacturer and condition of the opening—not a universal amount to subtract.
The supporting beam or lintel matters too. If an opening is being enlarged, structural design and building control requirements may apply. A bifold frame should never be expected to carry the weight of masonry without the support intended by the building design.
Thresholds, drainage and finished-floor levels
A low threshold can look attractive beside a patio, but weather resistance, drainage and accessibility depend on the full installation. Check where water will go, whether the paving falls away from the door and whether an outside step creates a trip risk. The finished internal floor may be higher or lower than the structural sill.
The frame height you order is influenced by the selected track and sill arrangement. Decide these details with the supplier before final measurements rather than assuming the lowest possible threshold will work on every exposed elevation.
A checklist before requesting prices
Give installers a simple plan showing approximate width and height, preferred panel count, opening direction, threshold preference, colour and whether access is easy. Ask each to clarify what is included: making good, lintel work, drainage, trims, VAT and the disposal of old doors.
For the differences between folding systems, use the standard bifold size guide. The site calculator helps with some full door projects, but it cannot survey structural openings or price lintel alterations.
One more thing worth checking
If a builder is forming the opening and another company is supplying the doors, clarify who confirms the final sizes and at what stage. Miscommunication between the two can leave the frame too tall for the finished floor or too wide for the weather seal details. Put that responsibility in writing before the brickwork is finished.
Do not cut masonry or place an order from a tape-measure sketch. Use rough dimensions for quotes, then insist on a documented professional survey.
Questions homeowners ask
How much should I subtract from the opening size?
There is no safe universal deduction. The supplier specifies manufacturing clearances after surveying the opening.
Does a low threshold change the measurement?
Yes. The sill and drainage design affect both fitted frame height and floor interfaces.
Can the calculator price structural alterations?
No. Structural opening work and lintel changes need a site-specific builder or installer quotation.
Related guides
Know what your quote should cost
Compare an independent estimate before you book installers. Choose the windows and doors that suit your home, then check the expected fitted price range.
Use our Quote Calculator →